World
Guns

Home

 

 

 

 

Bergmann Special Model2
Field Stripping

bergman1.gif (4861 bytes)
bergman2.gif (22752 bytes)

 

Field Strip To field strip the Bergman, first remove magazine and clear chamber. Pull down takedown latch (43) at front of trigger guard. Pull slide to rear as far as it will go and lift it free of frame. Slide (1) can now be run forward off barrel.
BergmanA2.gif Safety catch (10) must be removed to get at firing pin (9). Loosen detent retainer screw (11) and carefully remove detent components. Hold firing pin housing (7) and firing pin forward and free of seat in safety catch, and push up safety catch.
BergmanA3.gif (3676 bytes) Last coil of recoil spring (27) fits barrel very snugly and must be pushed free as shown, When replacing spring, be sure large end protrudes off barrel; otherwise gun cannot be reassembled.
BergmanA4.gif (10523 bytes) Magazine catch (34) hooks over a cress pin in frame and must be pushed back and lifted up fro removal. Use a screwdriver to ease it free and to prevent hammer spring (33) from throwing catch. Remove hammer sprig and strut (31)
BergmanA5.gif (4841 bytes) Trigger (23) houses 2 springs - trigger spring (26) and pin retainer spring (22). When reassembling gun, use slave pins to hold springs in place. Slave pins should be only as wide as trigger, and are pushed out when parts are pushed in.