World
Guns

Home

Radom Vis 35
Field Stripping

	Remove the magazine, draw back the slide far enough to put on the take-down latch (X). Pull forward on the exposed end of the recoil spring guide (HH) to relieve the tension on the slide stop (AA). At the same time, push out the slide stop. Release the take-down latch and draw the slide assembly off the front of the receiver. (If pistol has no take-down latch, retract the slide, depress hammer-lowering catch, and ease slide forward until catch engages notch on hammer.)
	To remove the firing pin (E), first remove the firing pin retainer plate (LL). Due to the split construction, the retainer plate sometimes gets wedged into the slide. So, insert a thin-bladed screwdriver as shown. Push in the firing pin (E) with a thin punch far enough to catch the shoulder on the pin and hold it out of the bushing, while prying the retainer plate down and out of the slide.
	To remove the extractor (C), pull out the recoil spring assembly (CC through HH) and disengage the barrel (II) from the slide. Remove the firing pin retainer plate (ll). Using a small screwdriver, press the extractor (C) outward toward the outside of the slide, pressing rearward at the same time. Remove the extractor through the rear of the slide.
	To remove the take-down latch (X), first cock the hammer. Hold the receiver (BB) as shown to depress the grip safety (L). Pull the take-down latch out slightly and turn it up as shown. To remove the latch, it may be necessary to wiggle it or move the safety slightly to free the pin. When the latch is removed, the grip safety (L) will drop free.
	The sear (NN) and disconnector (MM) will drop out when the sear and disconnector pin (Y) is removed. To reassemble, place the pieces together as shown. Drop the tail of the disconnector into the hole  in the receiver (BB). If the bearing holes do not line up with the hole in the receiver, pull the trigger a bit. This will usually line up the holes.
	The recoil spring on this gun must be removed as an assembly. To disassembly the recoil spring group (CC through HH),  squeeze the assembly slowly in a vise until the slotted  recoil spring guide (DD) is in as far as it can go. Now, using a thin punch, push put the spring guide retainer pin (EE0. It may be necessary to spread the coils of the spring to remove the pin.